Installation of solar street lamps

1. Fix the components of each part: fix the solar panel to the solar panel bracket, fix the lamp cap to the arm, then fix the bracket and arm to the main pole, and thread the connecting wire to the control box (battery box).
Before lifting the lamp pole, first check whether the fasteners at each part are firm, whether the lamp cap is installed correctly, and whether the light source works normally. Then, check whether the simple debugging system works normally; Loosen the solar panel connection wire on the controller, and the light source works.
When lifting the main lamp pole, pay attention to safety precautions; The screws must be absolutely tightened. If there is a deviation in the sunrise angle of the component, it is necessary to adjust its sunrise direction to fully face due south.
4. Put the battery into the battery box and connect the connecting wire to the controller according to the technical requirements; Connect the battery first, then the load, and then the solar panel; During wiring operation, it is necessary to pay attention to the correct connection between each circuit of wiring and the terminals marked on the controller. The positive and negative polarity cannot collide, and cannot be reversed; Otherwise, the controller will be damaged.
5. Whether the commissioning system works normally; Loosen the solar panel connecting wire on the controller, and the light will be on; Connect the solar panel connecting wire and turn off the light; At the same time, carefully observe the changes of each indicator light on the controller; Only when everything is normal can the control box be sealed.